BiXBiT firmware for ASIC antminer S17 / S17 Pro

The firmware designed for the Antminer S17 and S17 Pro models allows you to overclock the ASIC up to 90 Th/s. Supports AsicBoost technology. Increases the efficiency of equipment that operates on both immersion and air cooling.

Support and disscussion is on our Telegram
  • AsicBoost
    Technology
  • Overclocking
    up to 90 Th/s
  • DevFee is
    just 2.8%
  • Embedded
    Antivirus
  • Automatic
    frequency tuning

What are the features?

*Allows to adjust the frequency and voltage of the chips for Antminer S17, S17 PRO models.

  • Increases performance by up to 40% without the need to change or purchase a power supply.
  • Developer fee - 2.8%. VoskCoin recommend our firmware to use.
Support and disscussion is on our Telegram DOWNLOAD v2.0.4

Installation manual

Important!

Before preparing and installing, check the date of the current firmware. To do this, navigate to the System>Overview>File System Version section.

  • If the firmware date is before December 2019 (including), move to Step 1.
  • If the installed firmware is older than January 2020 (including), go directly to Steps 2 and 3.
  • Installed firmware has version December 2019 or earlier:

    Downloa and unpack UNLOCK SSH.

    Using notepad or a similar editor, correct individual settings in the settings.cfg file:

    IPNETWORK. The parameter must be set to the IP-address of your device. For example, if your IP-address is 191.123.100.*, then it should be IPNETWORK=191.123.100;

    PSTART and IPEND. You need to change the search range. For example, if your devices are in range from 192.168.100.1 to 192.168.100.40 - change parameters to IPSTART=1 IPEND=40;

    ASICWEBPASS. This should be your password from the Antminer web interface. View: ASICWEBPASS=your_password. By default, password is “root”;

    SSH ASICSSHPASS. Enter your password. View: SSH ASICSSHPASS=your_password. If you didn’t set this parameter, the default value is admin;

    Save the corrected file.

    To scan the network and unlock SSH, run the 1.unlock_ssh.bat script. The download will take about 2-5 minutes.

    To complete the unlock, run the script 2.replace.bat.

    Download and install firmware for S17 / S17 Pro.

  • Installed firmware version is January 2020 or later:

    Download the firmware image for S17 / S17 Pro versions.

    Format the SD card with the FAT32.

    Extract the files from the archive and transfer to the SD card.

    Using the instructions in the video below, prepare the ASIC for firmware installation:



    Download firmware for S17 / S17 Pro and move to Step 3

  • Installing BiXBiT Firmware for Bitmain S17 / S17 Pro:

    On the tab System>Upgrade, click Browse and navigate to the downloaded upgrade file.

    Select the firmware file then click Flash image.

    There will be appeared informing message that the AntMiner S17, S17 Pro firmware can be updated. Then the update will be started.

    When the firmware is updated, a message about successful installation will be appeared.

    Press Ctrl+F5 on your keyboard to reset the page cache.

Support and disscussion is on our Telegram