Firmware for ASIC Antminer T17+ from BiXBiT

The firmware from BiXBiT is designed for the ASIC Antminer T17+ model. Allows to overclock the miner up to 75 Th / s. Works on immersion or air cooling. Has AsicBoost technology.

Support and discussion is on our forum
  • AsicBoost
    Technology
  • Overclocking
    up to 75 Th/s
  • DevFee is
    just 2.8%
  • Embedded
    Antivirus
  • Automatic
    frequency tuning

What is special?

  • Allows you to adjust the frequency and change the voltage of the chips for the Antminer T17+ model.
  • Increases hardware processing power by 30%. You do not need to change or buy an additional power supply for this.
  • Has a built-in antivirus.
  • Reducing electricity consumption.
  • Developer commission – 2.8%.
Support and discussion is on our forum DOWNLOAD v2.0.4

Installation manual

Important!

Check the date of the installed firmware on the miner page, in the System>Overview>File System Version tab.

  • If the date of the installed firmware is December 2019 or earlier, go to the step 1 of this manual.
  • If the release date is January 2020 or later, go straight to the steps 2-3
  • Firmware version – December 2019 or earlier:

    Download and exctract UNLOCK SSH file.

    Using notepad or another editor, make changes to the settings.cfg file:

    Change the IPNETWORK value to your current IP-address. For example, if the IP-address of your device is 190.175.100.*, you should write IPNETWORK=190.175.100;

    Use the IPSTART and IPEND parameters to adjust the search range. For example, if your device has a range from 190.175.100.5 to 190.175.100.35, then you need to write: IPSTART=5 IPEND=35;

    In the ASICWEBPASS parameter you must enter the password that is relevant for your Antminer web interface. That is ASICWEBPASS=your_password. If you didn't set a password, the default value is root;

    For SSH ASICSSHPASS also enter the password in the format SSH ASICSSHPASS=your_password. If you didn’t set this parameter, the default is admin;

    Save the edited file.

    To scan the network and unlock SSH, run the 1.unlock_ssh.bat script. The process may take 2-5 minutes.

    Use the 2.replace.bat script to complete the SSH unlock process.

    Download and install BiXBiT firmware for T17+.

  • Installed firmware version is January 2020 (or later):

    Download image for the T17+ version.

    Format your SD card with the FAT32.

    Unzip the files and then transfer them to the SD card.

    Repeating the steps from the video below, prepare the ASIC for firmware installation:



    Download the BiXBiT firmware for T17+ and move to step 3.

  • Installing BiXBiT Firmware for Bitmain T17+:

    On the tab System>Upgrade, click Browse and navigate to the previously downloaded firmware file.

    Select the firmware file then click Flash image.

    There will be appeared informing message that the AntMiner T17+ firmware can be updated. Then the update will be started.

    When the firmware is updated, a message about successful installation will be appeared.

    Press Ctrl+F5 on your keyboard to reset the page cache.

Support and discussion is on our forum